Speakers

TeachLogic Voice Reinforcement System

  1. Turn on the amplifier

    1. Elementary: Hold the TeachLogic button on the left-hand side until it turns blue

    2. Middle & High: Hold the Power/Mute button on the wall-panel until the display turns on

  2. Turn on the pendant mic by holding the TeachLogic button in the middle until it lights up blue

Volume Control

  • Slide the rocker labelled ‘Priority’ up or down to raise or lower the volume, respectively
  • Adjust the knobs on the amplifier (silver models only)
  • Press the volume up or down arrows on either side of the power button under the display of the touch panel

Notes

  • Make sure the mic is always in line-of-sight to the sensor mounted on the ceiling (near the center of the room)
  • The pendant mic has an audio port on the bottom for an external audio source (your phone, computer, etc.)

Winbridge Portable PA

Pairing Headset to Speaker

  1. Charge both speaker and headset
  2. Turn on headset
  3. Turn on speaker
  4. Hit the [M]ode button twice to set speaker to UHF mode
  5. The speaker should report “UHF is waiting for a connection.” If it does not, try the following:
    - Hold the [M]ode button for 3 seconds (for sets with AC Adapter)
    OR
    - Tap the [M]ode button three times in quick succession (for sets with Micro-USB only)
  6. Hold the Pair button on the back of the headset until the speaker reports a successful pairing

Mic Volume Control

  • The headset mic has volume buttons on it, but there is also a Mic volume knob on the speaker itself.
  • Make sure to turn the knob on the speaker to set an initial mic volume before using the buttons on the headset.